Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] HS5 Network Switch mounting position

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] HS5 Network Switch mounting position
07-19-19, 01:42 PM (This post was last modified: 07-19-19 01:42 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] HS5 Network Switch mounting position
Welcome back to the Raymarine Forum Pete,

Q1. why the vertical mounting?
A1. By installing the HS5 RayNet Network Switch in the specified orientation,
- the keyhole openings will be properly oriented to prevent the switch from coming loose from the bulkhead / mounting surface that it will be attached to.
- maximum protection against water/condensation infiltration will be achieved, as any such moisture will not drip down the cables toward the switch's connectors.

Q2. Does it even generate heat?
A2. The specified installation orientation is not for heat dissipation purposes.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] HS5 Network Switch mounting position - Chuck - Raymarine - Moderator - 07-19-19 01:42 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication