The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] No contact with ITC-5, Seatalk Ng

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] No contact with ITC-5, Seatalk Ng
07-29-19, 08:42 AM (This post was last modified: 08-01-19 09:24 AM by Chuck - Raymarine - Moderator.)
Post: #1
Kornelia Offline
Junior Member
**
 		Posts: 2
Joined: Jul 2019
Reputation: 0
[CA11] No contact with ITC-5, Seatalk Ng
As a newbie, I try my first post in this forum:

I run a standard Seatalk Ng network powered by an ACU-200. To the network, an Axiom plotter and an Evolution autopilot is connected.

The plan was to install the combined echosounder/speed/temperature sensor (DST800) by use of an ITC-5 converter. This is when the problem started:

I see that the ITC-5 diods flashes for the connected sensors. I take that as a proof that the back bone cable is OK. Is that correct?

According to the Axiom, no sensors are connected to the network. The first guess would be the cables from the ITC-5 to the sensor. But how and where do I measure?

I.e. between which cables?


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] No contact with ITC-5, Seatalk Ng - Kornelia - 07-29-19 08:42 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication