The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] st6002 control by chart plotter

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] st6002 control by chart plotter
08-17-19, 09:13 PM (This post was last modified: 08-22-19 03:27 PM by Chuck - Raymarine - Moderator.)
Post: #1
chriscd Offline
Junior Member
**
 		Posts: 5
Joined: Aug 2018
Reputation: 0
[CA11] st6002 control by chart plotter
I did something to the E120 chart plotter that told it to take control of the ST6002 autopilot. I guess it was “tracking” .
Since then the autopilot has been displaying an incorrect heading
And behaving erratically, sometimes it drifts to an incorrect heading and sometimes is radically changes direction of the boat. It is not trustworthy.

Not sure what screen or commands I was in when I told the e120 to control the autopilot. Where in the menu does it say that the autopilot controller is on or off?
E120 Menu
System setup
SYStem integration setup
Autopilot control disabled
this still does not fix the problem. what do i need to do here. it was working fine
until i did something to the E120.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] st6002 control by chart plotter - chriscd - 08-17-19 09:13 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication