[CA] [CA11] Multiple Axiom interfacing issues

[dpddj]

Hello - it seems everything I could search is for older MFDs. I have a new Axiom Pro 9 and a new Axiom 9. The Pro9 is intended to be the data master. Both units have the latest software updates. I have a few questions:

1) Under network, the Axiom 9 also indicates it is the data master, so both MFDs want to be DM. I cannot fiind a way (including factory reboot) to turn off A9 DM. The A9 does see the AP9 and is set up to get the time and GPS info from the AP9. The A9 also sees the AIS that plugs into the SeaTalk connector.

2) The Quantum radar plugs into AP9, into a network port. FYI, the radar works and shows up on the AP9. The radar does not show up on the A9, even when I try to start it from A9. I prefer to not go WIFI for A9.

3) On the AP9, There is a cable from the NEMA2000 port into the SeaTalk connector. The A9 also plugs into the connector.

4) Both MFDs are on the same display group.

5) Final one!! I run Navionics charts on the AP9. I cannot get the A9 to see these charts. I was told I would not have to buy additional charts for the A9, that the two would share the charts.

Obviously, I have some issues and I can't figure it out. I very much appreciate your help. Thanks!