[DG11] type 3 hydraulic linear

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] type 3 hydraulic linear

11-05-19, 06:24 PM (This post was last modified: 11-07-19 10:50 AM by Derek - Raymarine - Moderator.)

Post: #1

shparrot Offline

Junior Member

Posts: 16
Joined: Oct 2018
Reputation: 0

[DG11] type 3 hydraulic linear

I am hoping to install a type 3 drive into a cramped area. There is plenty of clearance fore and aft and to each side, however I only have 115mm of vertical space to work with. Your drawing shows an 80mm profile but does not indicate where the hydraulic fittings are. Are they mounted on top?
If there isn't enough clearance is it safe to mount the pin connecting the ram end to the tiller arm upside down?

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] type 3 hydraulic linear - shparrot - 11-05-19 06:24 PM

RE: [DG11] type 3 hydraulic linear - Derek - Raymarine - Moderator - 11-07-19, 11:17 AM

User(s) browsing this thread: 1 Guest(s)