[DG] [DG11] E120 problem getting past Limitation on Use page

[Derek - Raymarine - Moderator]

Hi Seeray96

Thank you for your enquiry

This suggests that you have an MFD referred to as an E classic. The most probable solution is to carry out a factory reset, this is done as follows . . .

* With the unit turned off press and hold the left hand soft key
* Keep it pressed and turn the unit on
* On screen it will say 'Factory Reset' and count down from 3
* Unit will reset and load into normal operation. This can take a couple of extra minutes than normal.

**Please make sure you back up all Waypoints and Routes etc to a separate Compact Flash Card other than your Cartography Card**

Regards
Derek