Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Intagration of the ClearCruise System

Post Reply 
 
Thread Rating:
  • 2 Vote(s) - 2.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Intagration of the ClearCruise System
12-06-19, 08:54 PM
Post: #11
jefndeb Offline
Mainship 400
***
 		Posts: 54
Joined: Feb 2016
Reputation: 0
RE: [CA11] Intagration of the ClearCruise System
OK, thanks Chuck..

I checked and verified that on the second seatalk port of the computer, (the wire I added) only the data/yellow wire is connected. Red wire was capped and secure,..

I moved the yellow seatalk cable that comes from the NG converter over to the 8002 head and powered it all back up and it says "no pilot".

At this point I think that this seatalk port is bad..i am guessing both ports should do the same thing...so i reconfigured the displays to all be one the one working seatalk bus and then the NG converter was an option as a heading source on the Axiom...it was actually already selected..everything seems to work now.

Is this ok as a temp config ? I attached a picture of the mod.

I have a spare X30 that I could install in place of this S2G (E12091)

Good idea?


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Intagration of the ClearCruise System - jefndeb - 12-06-19 08:54 PM

Forum Jump:


User(s) browsing this thread: 7 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication