[CA] [CA11] Configure New Network and Incorporate S2 Course Computer

[ventus]

Hi Chuck,

Almost there....

Updated diagram attached.

I looked up the LEN loads and added a few things. I wasn't sure of the LEN loads of the following, do you know?

T70134
E70196
E22158
A06064

Also not sure if the S2 Course Computer and Icom VHF had any LEN?

I added the Fusion Stereo and moved the power connection spur over to try and help center the load. As I see it now aside from the above listed...I have 6 LEN on one side and 8 LEN on the other. Is this acceptable? I dont think I can run the RS150 GPS all the way to the nav station because I am fairly certain it is farther than 20' (spur cable that comes with RS150 is roughly 20').

I also added Quantum 2 Radar in blue since it will be a future purchase but wanted to show the entire system. I believe it only connects to the HS5 Network Switch via Raynet cable so would not have a LEN load on the backbone, correct? I also added it to page 2 for its power connection with a 5 amp fuse, correct?