The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [LW] [LW11] Replacing ST6001 with p70s

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] Replacing ST6001 with p70s
02-02-20, 03:55 AM (This post was last modified: 02-03-20 05:51 AM by Louise - Raymarine - Moderator.)
Post: #1
Planke Offline
Junior Member
**
 		Posts: 8
Joined: Mar 2019
Reputation: 0
[LW11] Replacing ST6001 with p70s
Hello,

my setup on board is a ST6001 autopilot instrument, S2/400 course computer (assumed), flux-gate compass and hydraulic steering.

Would the autopilot be fully functional including the calibration of the fluxgate, if I replace the ST6001 with a new instrument?
Will the eS78 MFD autopilot support wwork, if I replace the instrument only?

Course Computer: As I have no documents about the course computer, I am not really sure which type of course computer I have. The system was purchased 2004, the PCB is labeled with "C/Comp 400 23928".

Thank you in advance.

Kind regards,

Ralf
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[LW11] Replacing ST6001 with p70s - Planke - 02-02-20 03:55 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication