[LW] [LW11] AIS700 do not send position data to DSC VHF

[capmax1]

Dear Louise,
according to your suggestion I have:

1) set all options GBS, GGA, GLL & RMC on the Output GNSS Sentences. Confirmed with the “Write Configuration” soft key on ProAIS2.
2) Tested the NMEA LO OUT signal (see attachment with picture). No signals on the exit both if the DCS VHF connector is unplugged or plugged.

3) Satellite signals are visible. Pls refer to the attachment.

4) Other Vessels are visible.

5) Diagnostic seems perfect; all green ticks are shown (Also silent mode is detected when the HW Switch is in correct position).

6) Serial Data are also present..

I'm in the harbor till Sunday End your time for any additional test.

As I saw the data on my DCS VHF BEFORE AIS700 SW updateh I'm asking if this SW revision can be suspected for the missing DCS VHF Lat, Long, UTC data transfer.

Thanks for your time and
Cheers Max