[TG] [TG11] B260 transducer - early failure?

[Tom - Raymarine - Moderator]

Hello boudreaux77450,

These transducers don't generally fail frequently like this. There are a few reasons that I can see why you might get repeat failures:

• The old L125 perhaps isn't operating correctly, and may be outputting at the wrong power or frequency
• Through-hull bronze transducers need to be installed according to the letter of the installation manual and coated with sealant on the top (and often sides - see your transducer's manual) in order to prevent water ingress into the transducer. If not correctly installed, transducers can get water inside.
• Use out of the water. Transducers need the mechanical resistance of the water against their face in order to cushion and buffer them and allow them to resonate correctly and present the correct electrical impedance to the sounder. The number 1 reason for failure of high-power transducers is operation out of the water.
  

I would suggest having your nearest good Raymarine Certified service dealer to test the transducer with an Airmar transducer test set and ideally the output of the display with an oscilloscope or EDI sonar test set in order to find out what is going on.

To answer your last question: no, transducers are sensitive ceramic elements fully potted/sealed into the housing and cannot be opened or serviced.

Regards,
Tom