Raymarine forum / Raymarine Forums / Multifunction Displays v / [TG] [TG11] Axiom - Fuel Remaining shows ---, why?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Axiom - Fuel Remaining shows ---, why?
05-21-20, 10:32 PM
Post: #3
Tom - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,067
Joined: Nov 2017
Reputation: 7
RE: [TG11] Axiom - Fuel Remaining shows ---, why?
Hello Dave,

Sorry for the delay replying.

The MFDs need to see a certain amount (I thought it was 1 litre but perhaps it's a little higher) in order to start updating the estimated/calculated fuel values. At low fuel burn rates this can indeed take quite a while. I agree that this should probably be made clear in the operation manual. In most cases it's not an issue because burn rates are high-enough that small usage doesn't take long to go through and data appears quickly.

Regards,
Tom
Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Axiom - Fuel Remaining shows ---, why? - Tom - Raymarine - Moderator - 05-21-20 10:32 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication