The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / ST50+ Wind factory reset

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST50+ Wind factory reset
03-07-16, 11:19 AM
Post: #1
miken6mz Offline
Junior Member
**
 		Posts: 1
Joined: Feb 2016
Reputation: 0
ST50+ Wind factory reset
Good morning. Last week I successfully repaired my ST50+ Wind (without schematics!); there was a faulty semiconductor on the anemometer board in the masthead transducer and also a faulty transistor in the control head. I want to perform a factory reset and then linearize and calibrate the transducer again. I found the procedure to do the factory reset for an ST60+ Wind in that manual, but I cannot find the factory-reset procedure for the ST50+. Can you help? Thanks in advance.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST50+ Wind factory reset - miken6mz - 03-07-16 11:19 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication