[CA11] CP570 to 3KW Transducer Upgrade from 2KW

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] CP570 to 3KW Transducer Upgrade from 2KW

03-17-20, 03:06 PM (This post was last modified: 03-17-20 03:13 PM by Chuck - Raymarine - Moderator.)

Post: #7

Fish On Offline

Member

Posts: 108
Joined: May 2016
Reputation: 0

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW

Chuck, TY so much to clarify. Is the RV212 a conical chirp transducer?
Getting the right transducer is a tough choice without making the bottom of your boat looking like swiss cheese. Will get the cp570, with R111LM, and swapping out the R109LH to a R109LHW. The RV212 will take care of my inshore; Low/High.
This set up I have the best of all worlds. Low, Med. HIgh, and High Wide. Inshore, offshore trolling, bottom fishing, and chunking offshore.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] CP570 to 3KW Transducer Upgrade from 2KW - Fish On - 03-12-20, 02:05 PM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Chuck - Raymarine - Moderator - 03-12-20, 02:26 PM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Fish On - 03-12-20, 02:45 PM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Chuck - Raymarine - Moderator - 03-13-20, 09:21 AM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Fish On - 03-13-20, 09:41 AM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Chuck - Raymarine - Moderator - 03-17-20, 02:56 PM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Fish On - 03-17-20 03:06 PM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Chuck - Raymarine - Moderator - 03-17-20, 04:01 PM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Fish On - 03-17-20, 04:41 PM

RE: [CA11] CP570 to 3KW Transducer Upgrade from 2KW - Chuck - Raymarine - Moderator - 03-18-20, 08:19 AM

User(s) browsing this thread: 1 Guest(s)