The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] connecting multiple mfds

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] connecting multiple mfds
04-12-20, 07:59 AM (This post was last modified: 04-13-20 01:39 PM by Chuck - Raymarine - Moderator.)
Post: #1
rlynn12 Offline
Junior Member
**
 		Posts: 1
Joined: Jul 2018
Reputation: 0
[CA11] connecting multiple mfds
I am currently using a Raymarine Axiom Pro. I then installed a Axiom 7 to monitor my engines, etc through the Dashboard. Everything worked fine until I installed a Real Vision transducer to the Axiom 7.
While underway, a wide red/pink track appeared on my Axiom Pro navigation chart. After some investigation, I found that I had a "Sonar Live" enabled in the Axiom 7 which I assume was coming up on the Axiom Pro chart. After I disabled the Sonar Live, the red/pink track was still appearing on my chart and I have been unable to get rid of it.
Both MFD's are connected individually through the NMEA 2000 backbone.
My question is 1) How do I get rid of this red/pink lines and 2) Should the two MFD's be in some kind of network and not connected individually? 3) if yes to question 2, is there a diagram somewhere showing how to do that?


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] connecting multiple mfds - rlynn12 - 04-12-20 07:59 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication