The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Change auto tack on EV-100

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Change auto tack on EV-100
04-24-20, 11:27 AM (This post was last modified: 04-24-20 03:31 PM by Chuck - Raymarine - Moderator.)
Post: #1
Gulfstar 37 Offline
Junior Member
**
 		Posts: 3
Joined: May 2016
Reputation: 0
[CA11] Change auto tack on EV-100
I have a EV-100 autopilot with a P70s control head installed and intergrated to a Axiom MFD.

Is there a user selection input to change the auto tack function (+_1 +_10 buttons pushed together) value from 90 degrees to another value say between 90 and 100 degrees? If so what procedure is used to do this? If not so could this be a future software updates?

I single hand quite a bit and currently use the auto tack function quite a bit with additional a series of 1 or 10 degree adjustment all while attending to jib sheets etc.

Thanks.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Change auto tack on EV-100 - Gulfstar 37 - 04-24-20 11:27 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication