Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Wiring Axiom when replacing E97
05-13-20, 01:50 AM
Post: #2
RE: [TG11] Wiring Axiom when replacing E97
Hello Grady330,

If you have a look at the e-Series' installation manual, you'll see that the yellow-brown on its power cable are the NMEA0183 output +ve and -ve respectively. What document are you reading that describes them as 'trigger'? Commonly they would provide GPS data to a VHF or navigation data to a non-Raymarine autopilot, for example.


Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: [TG11] Wiring Axiom when replacing E97 - Tom - Raymarine - Moderator - 05-13-20 01:50 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)