[TG11] How do I network a second Axiom9.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] How do I network a second Axiom9.

06-10-20, 12:23 AM

Post: #2

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] How do I network a second Axiom9.

Hello tjwatt,

Assuming the Raynet network port in your existing display is available (not already connected to a radar or sounder module) then you simply need a Raynet cable of the right length to connect them together. If your Raynet network port is in use already then you need to connect both displays and the other device to an HS5 network switch. You'll probably need a couple of Raynet cables to make that happen.

Make sure you update both displays to the same (latest) software version too.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] How do I network a second Axiom9. - tjwatt - 05-31-20, 02:48 PM

RE: [TG11] How do I network a second Axiom9. - Tom - Raymarine - Moderator - 06-10-20 12:23 AM

User(s) browsing this thread: 1 Guest(s)