Raymarine forum / Raymarine Forums / Instruments v / [CA] Setting depth offset

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Setting depth offset
12-12-17, 02:24 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA] Setting depth offset
Welcome to the Raymarine Forum Robert,

If an iTC-5 has been installed within a system, then in i70/i70S MFID must also be installed within the system. Depth offset would then be configured within the menus of the i70/i70S MFID. Should the eS98 MFD's transducer port be interfaced to a high CHIRP (conical) / DownVision transducer, then the system would feature multiple depth data sources. In such systems, the MFD's Data Sources feature (HOME->SET-UP->SYSTEM SETTINGS->DATA SOURCES) must be used to specify which source of depth will be used by the Raymarine system.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA] Setting depth offset - Chuck - Raymarine - Moderator - 12-12-17 02:24 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication