Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] What is inside the hump on the back of the a78?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] What is inside the hump on the back of the a78?
06-20-18, 03:51 PM (This post was last modified: 06-20-18 03:52 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] What is inside the hump on the back of the a78?
Welcome to the Raymarine Forum Bruce,

The hump which you have referenced houses a circuit board with a transformer and a few large capacitors. That said, such breaches to a product's case would quite possibly void the product's warranty. Ram offers mounts having flat bases to accommodate the MFD's trunion bracket. Additionally, the pod / mounting surface in which the MFD will be installed must have sufficient clearances to satisfy the requirements specified within the a-Series Product Dimensions section of Chapter 3.13 Selecting a location of the a/c/e-Series MFD Installation Instructions.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] What is inside the hump on the back of the a78? - Chuck - Raymarine - Moderator - 06-20-18 03:51 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication