The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] Ray 52 NMEA out issue
07-06-18, 09:47 AM (This post was last modified: 07-08-18 10:01 PM by Tom - Raymarine - Moderator.)
Post: #1
Ray 52 NMEA out issue
I am trying to interface my Ray 52 NMEA out to supply GPS speed to my yamaha command link system, but I can not get it to work. I have ensured I have the correct NMEA 0183 protocol selected in the Ray 52 and have ensured it is wired correctly using the NMEA out wires. I recently upgraded to the 3 (2x12", 1x9") Axioms MFDs and have networked everything together. Previously I had a E127 and E125, and I had no issue with using the Ray 52 to supply the GPS information while everything was networked.

I have tried all three networking protocols for the NMEA out (std speed, high speed, NMEA 2000) with no luck. I even replaced the wiring harness from the yamaha command link and that didn't work.

I disconnected the Ray 52 from the network to see if there was some sort of data corruption occurring through the network. The internal GPS seems to be working fine but it appears no data is being sent through the NMEA out wires.

Any ideas?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Ray 52 NMEA out issue - Robinsonh2o - 07-06-18 09:47 AM
RE: Ray 52 NMEA out issue - Robinsonh2o - 07-10-18, 07:57 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)