[TG11] RL80C Plus system - all functions work but not at both MFDs

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] RL80C Plus system - all functions work but not at both MFDs

10-07-18, 01:50 PM (This post was last modified: 10-10-18 08:16 AM by Chuck - Raymarine - Moderator.)

Post: #1

Boblloyd Offline

Junior Member

Posts: 3
Joined: Sep 2018
Reputation: 0

[TG11] RL80C Plus system - all functions work but not at both MFDs

Hi,

I bought a boat with RL80C Plus system with two MFDs, GPS, Pathfinder Radar, sonar, and ST6001 autopilot. On the Lower MFD the chart plotter GPS and radar work fine but the sonar isn't an available display. On the Upper MFD the sonar works fine and the radar is offered as a display but always shows a "Scanner Not Responding" message. The Chart plotter isn't even offered as a display on the upper MFD. The autopilot works fine at both locations. The lower MFD has two slots for C-MAP with one installed.

I understand this system depends on Seatalk as well as HSB2. Any thoughts on where to start with this problem?

Thanks, Bob

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] RL80C Plus system - all functions work but not at both MFDs - Boblloyd - 10-07-18 01:50 PM

RE: [TG11] RL80C Plus system - all functions work but not at both MFDs - Tom - Raymarine - Moderator - 10-07-18, 08:16 PM

RE: [TG11] RL80C Plus system - all functions work but not at both MFDs - Boblloyd - 10-09-18, 05:18 AM

RE: [TG11] RL80C Plus system - all functions work but not at both MFDs - Tom - Raymarine - Moderator - 10-12-18, 01:32 AM

RE: [TG11] RL80C Plus system - all functions work but not at both MFDs - Boblloyd - 10-13-18, 07:08 PM

RE: [TG11] RL80C Plus system - all functions work but not at both MFDs - Tom - Raymarine - Moderator - 10-15-18, 01:36 AM

User(s) browsing this thread: 1 Guest(s)