[CA11] SP-X10 calibration

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] SP-X10 calibration

04-27-19, 01:54 AM (This post was last modified: 04-29-19 12:26 PM by Chuck - Raymarine - Moderator.)

Post: #1

Phillip Offline

Junior Member

Posts: 1
Joined: Sep 2017
Reputation: 0

[CA11] SP-X10 calibration

Hi, I have a used SP-X10 with an ST-6002 control head. I installed it and went through the calibration process (several times). Each time I turn the power off I get a message on the control head "Required Calibrn". I set the boat type to Sail Boat. I also did a "swing" and have a deviation of 9 degrees. Why does it still display Required Calibration?

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] SP-X10 calibration - Phillip - 04-27-19 01:54 AM

RE: [CA11] SP-X10 calibration - Chuck - Raymarine - Moderator - 04-29-19, 12:31 PM

User(s) browsing this thread: 1 Guest(s)