Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST60 to i50 conversion
05-09-19, 01:42 PM
Post: #2
RE: [CA11] ST60 to i50 conversion
Welcome to the Raymarine Forum Mitch,

As you had suggested, one need simply removed the transducer leads from the ST60 Tridata and then mate them to the same color coded terminals of the i50 Tridata. However, when interfacing the i50 Tridata to an existing SeaTalk bus, the following two additional components are required:
- a D244 SeaTalk Junction Block
- an A06057 SeaTalk Adapter Cable

The press-fit / three pin plug which had connected the ST60 Tridata to the SeaTalk bus will be unplugged from the ST60 Tridata instrument's SeaTalk socket and will instead be connected to the aforementioned D244 SeaTalk Junction Block. The aforementioned A06057 SeaTalk Adapter Cable will then be used to interface the i50 Tridata to the D244 SeaTalk Junction Block.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] ST60 to i50 conversion - _mitch_ - 05-08-19, 08:40 AM
RE: [CA11] ST60 to i50 conversion - Chuck - Raymarine - Moderator - 05-09-19 01:42 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)