[CA] [CA11] CAM210 wiring and mounting advice
|
10-23-19, 06:26 PM
(This post was last modified: 10-24-19 02:16 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] CAM210 wiring and mounting advice
I am trying to connect the CAM210 to an axiom 12. I have secured a 35 ft RJ45 to device net cable but It looks as though that is not going to be able to do the POE that way.
It looks as though I have two options 1. hard wire it and use the cable I have to get the data to the MFD and then hardware the camera 12vdc lead 2. Run the existing cable to a poe device and take another cable out to the CAM210. Another issue I foresee is how to get the connection madeup. My selected location would be in my hard bimini (has a targa built into the aft part that allows for wire to go through). There is a waterproof connector for the RJ45 included in the camera box. This thing is about 4-5 inches long. It would look awful if this was outdoor, and I cant make the connection inside the targa as I can not reach it. Assuming the leads are supposed to go through the large [censored] on the mount but can not tell whether this is supposed to be caulked wih some UV4000 or something. Thinking that a large [censored] under the mount will allow me to make the RF45 connection and thread it into the targa. Any input would be helpful. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] CAM210 wiring and mounting advice - firstlight38 - 10-23-19 06:26 PM
RE: [CA11] CAM210 wiring and mounting advice - Chuck - Raymarine - Moderator - 10-24-19, 02:36 PM
RE: [CA11] CAM210 wiring and mounting advice - firstlight38 - 10-24-19, 06:12 PM
RE: [CA11] CAM210 wiring and mounting advice - Chuck - Raymarine - Moderator - 10-25-19, 08:34 AM
|
User(s) browsing this thread: 1 Guest(s)