[CA] [CA11] CAM210 wiring and mounting advice
|
10-24-19, 06:12 PM
(This post was last modified: 10-25-19 08:33 AM by Chuck - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
RE: [CA11] CAM210 wiring and mounting advice
Q1. I have secured a 35 ft RJ45 to device net cable
A1. Is it possible that you meant that you have secured a 35' RJ45 (M) to RayNet (F) Cable?----- YES Q2. It looks as though I have two options 1. hard wire it and use the cable I have to get the data to the MFD and then hardware the camera 12vdc lead 2. Run the existing cable to a poe device and take another cable out to the CAM210. A2. These are certainly options. However, as the CAM210 features a RJ45 (M) dongle, most will connect the supplied waterproof coupler to the dongle and then connect the other end of the coupler to an appropriate length of quality shielded CAT6 patch cable. The other end of the CAT6 patch cable will be joined the POE end of a POE injector or POE Switch (installed in a convenient, dry location). The non-powered socket of the POE injector or POE Switch will in turn be connected to the MFD or HS5 RayNet Network Switch via an appropriate length of RayNet (F) to RJ45 (M) Cable. The cable I have will go from the MFD to either the Injector OR directly to the RJ45 adapter (depending on if its POE or remote powered) |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] CAM210 wiring and mounting advice - firstlight38 - 10-23-19, 06:26 PM
RE: [CA11] CAM210 wiring and mounting advice - Chuck - Raymarine - Moderator - 10-24-19, 02:36 PM
RE: [CA11] CAM210 wiring and mounting advice - firstlight38 - 10-24-19 06:12 PM
RE: [CA11] CAM210 wiring and mounting advice - Chuck - Raymarine - Moderator - 10-25-19, 08:34 AM
|
User(s) browsing this thread: 1 Guest(s)