Raymarine forum / Raymarine Forums / Autopilots v / NO PILOT message from Smart Pilot X-5

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NO PILOT message from Smart Pilot X-5
08-25-17, 09:33 PM
Post: #1
Houler43 Offline
Junior Member
**
 		Posts: 1
Joined: Aug 2017
Reputation: 0
NO PILOT message from Smart Pilot X-5
gnI am getting the No Pilot message and want to know where to start on figuring this out. The AP is connected to a C90W plotter which confirms that no heading data is available. The controller is receiving power. Where do I start?
Find all posts by this user
Quote this message in a reply
08-28-17, 03:55 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: NO PILOT message from Smart Pilot X-5
Welcome to the Raymarine Forum Houler43,

Please click here to view a FAQ addressing this subject. Whereas the system is not reporting a value for heading, I would recommend that troubleshooting begin with verification that that the circuit supplying power to the autopilot course computer is switched ON and that it's connection to the SeaTalkng backbone good. If so, then it would be recommended that the autopilot course computer be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication