ST2000+ broken gaskets
|
08-26-17, 08:39 AM
Post: #1
|
|||
|
|||
ST2000+ broken gaskets
I found some broken gasket parts inside our ST2000+.
Is one of them from the pushrods exit end of the unit? Appears as though the other one might be a bushing from behind the largest gear on the belt/gear arrangement? Are these parts available? The unit was failing due to these parts falling underneath the internal compass gimbal, restricting its movement. |
|||
08-28-17, 03:59 PM
Post: #2
|
|||
|
|||
RE: ST2000+ broken gaskets
Welcome to the Raymarine Forum Maluhia,
Raymarine does not consider the ST2000+ to be an end user repairable item. Accordingly, internal parts and repair instructions are not available. It is recommended that the ST2000+ be sent to Raymarine’s Product Repair Center to be bench checked / serviced. |
|||
08-29-17, 02:48 PM
(This post was last modified: 08-29-17 04:19 PM by Chuck - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
RE: ST2000+ broken gaskets
Thanks Chuck.
Removed gasket shrapnel, unit tested o.k. in 5 foot waves and 18-20 kits of wind in AUTOmfor an hour or so. It did experience a power interruption, but immediately turned back on in STANDBY mode. (it was powering off before after a few minutes of use, and not coming back on) |
|||
08-29-17, 04:19 PM
Post: #4
|
|||
|
|||
RE: ST2000+ broken gaskets
You're welcome.
|
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)