Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Axiom networking using wifi

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom networking using wifi
12-31-18, 03:26 PM (This post was last modified: 01-02-19 10:26 AM by Chuck - Raymarine - Moderator.)
Post: #1
philduff Offline
Junior Member
**
 		Posts: 5
Joined: Jan 2018
Reputation: 0
[CA11] Axiom networking using wifi
I have seen this thead discussing sharing over wired network.

Is it viable to use 1 or 2 Axiom MFDs as slaves, connected via wifi to a master Axiom MFD, which in turn is connected to the STng network?
Potentially the master MFD could be connected via wired ethernet to a Wifi router/AP, such that the slaves could also connect to the router.
I'm hoping to share charts and data without wired ethernet to the slaves.

Regards
Phil
Find all posts by this user
Quote this message in a reply
01-02-19, 10:29 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Axiom networking using wifi
Welcome to the Raymarine Forum Phil,

Q. Is it viable to use 1 or 2 Axiom MFDs as slaves, connected via wifi to a master Axiom MFD, which in turn is connected to the STng network?
A. Negative. Raymarine's MFDs featuring an Ethernet communications interface(s) are designed to be interfaced to one another via a wired Ethernet network.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication