ST50+ Wind factory reset

[miken6mz]

Good morning. Last week I successfully repaired my ST50+ Wind (without schematics!); there was a faulty semiconductor on the anemometer board in the masthead transducer and also a faulty transistor in the control head. I want to perform a factory reset and then linearize and calibrate the transducer again. I found the procedure to do the factory reset for an ST60+ Wind in that manual, but I cannot find the factory-reset procedure for the ST50+. Can you help? Thanks in advance.

[Steve - Raymarine - Moderator]

There is no Reset with the ST50+ product line. You can adjust the alignment, but that is it. The ST50+ wind instrument needed a machine in our service department to reset to board. That is no longer available.