Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] converting fsh to Gps
12-20-19, 12:06 PM (This post was last modified: 12-20-19 01:57 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] converting fsh to Gps
converting fsh to Gpx for my E140W
Find all posts by this user
Quote this message in a reply
12-20-19, 01:59 PM
Post: #2
RE: [CA11] converting fsh to Gps
Welcome to the Raymarine Forum Jim,

A GPX file containing 2342 waypoints and 1 track has been e-mailed to you. This data was retrieved from your archive.fsh file by a MFD running LightHouse II v13.37 software. The MFD was then commanded to exported by the MFD to the attached GPX file. It should be noted that the waypoint names and/or comments within your archive.fsh file and the subsequently produced GPX file … most notably with regard to the inclusion of apostrophes within the waypoint names. As indicated, a FAQ has been written address the constraints for waypoint names and comments. This FAQ may be found here. To prevent any future issues related to these constraints when using a Raymarine MFD or third party chartplotting product / software, it is recommended that the naming constraints within the referenced FAQ be heeded and that the names of your waypoints be changed to comply with these constraints
Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)