Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] How to chose the FISHFINDER temperature sensor as the data source?
02-29-20, 06:53 AM (This post was last modified: 03-02-20 11:40 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] How to chose the FISHFINDER temperature sensor as the data source?
My main water temperature source from my DTS800 is showing the wrong temperature. After a year, the temperature started to increase and I calibrated it fairly often. It's now out of range of calibration, and is now showing a water-temp of more than 30C, when it's 13C in the water. The water temperature in the FISHFINDER app seems OK though. But I do not know how to make that the "System Temperature Data Source", which would solve the problem.

On my i70s Multifunction Instrument I see the following:
Transducers found:
- DST800 (which is showing the wrong temp)
- iTC-5

In the FISHFINDER app I see the CPT-S transucer.
Find all posts by this user
Quote this message in a reply
03-02-20, 11:48 AM
Post: #2
RE: [CA11] How to chose the FISHFINDER temperature sensor as the data source?
Welcome to the Raymarine Forum andersrho,

Unfortunately, water/sea temperature source cannot be selected. Please click here to view a FAQ addressing water temperature prioritization with Multiple Data Sources. As STng has the highest priority, the only way force the system to utilize water/sea temperature from the fishfinder transducer would be to disconnect the DST800 from the backbone ... or to replace its insert.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)