Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST-60 wind inst T/S
05-03-20, 06:51 PM (This post was last modified: 05-07-20 09:51 PM by Tom - Raymarine - Moderator.)
Post: #1
ST-60 wind inst T/S
so I have a full ST60 package, wind, speed, depth. Wind cups were damaged. Cups replaced, instrument worked fine for a few days and went wacky. ST60 wind inst powers up but no data displayed (no needle movement). How can I T/S the wires coming down (what voltage should be on red etc) and how can I T/S the display assuming the information is making it through the wires.
Find all posts by this user
Quote this message in a reply
05-07-20, 09:55 PM
Post: #2
RE: ST-60 wind inst T/S
Hello Eheim,

There are voltage measurements for the windvane on this FAQ. I suspect you'll see incorrect voltages on either blue or green (the wind angle pair that the system uses to detect that the windvane is there.


Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)