Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] EV 150 Autopilot
05-05-20, 06:18 PM (This post was last modified: 05-07-20 11:42 PM by Tom - Raymarine - Moderator.)
Post: #1
EV 150 Autopilot
My 42 power boat has a Seastar 2- hydraulic steering system with a Ba 175 -7Tm cyclinder ( model HC5319) . The steerng system has 2 hoses between the helm and rudder cylinder .

I purchased a Raymarine EV 150 AutoPilot system with a Type 1 drive motor . Must I run a ( new) low pressure hose from the new drive pump to the helm assembly?

Thanks

Reale
Find all posts by this user
Quote this message in a reply
05-07-20, 11:45 PM
Post: #2
RE: EV 150 Autopilot
Hello Reale,

Yes, the Reservoir line from the helm reservoir to the autopilot pump is required. A typical system is shown by the 'Two line' illustration in the pump installation guide.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)