Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Wiring Axiom when replacing E97
05-09-20, 04:46 PM (This post was last modified: 05-13-20 01:47 AM by Tom - Raymarine - Moderator.)
Post: #1
[TG11] Wiring Axiom when replacing E97
There is a small gray cable that has a white and a black wire in it. It is connected to a brown and yellow wire coming out of the main power cable for the E97. The wiring diagram for the E97 shows the yellow wire has to do with the “Tx trigger”. I assume this is for my HD Color Radar? I don’t see this wire in the radar manual. Any ideas?
Find all posts by this user
Quote this message in a reply
05-13-20, 01:50 AM
Post: #2
RE: [TG11] Wiring Axiom when replacing E97
Hello Grady330,

If you have a look at the e-Series' installation manual, you'll see that the yellow-brown on its power cable are the NMEA0183 output +ve and -ve respectively. What document are you reading that describes them as 'trigger'? Commonly they would provide GPS data to a VHF or navigation data to a non-Raymarine autopilot, for example.

Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)