Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
i60 Wind - No wind speed Readings
05-17-20, 02:57 PM
Post: #1
i60 Wind - No wind speed Readings
I have an i60 wind software version 1.05- wind speed has either stopped working or shows erratic numbers some of which might be correct- wind angle seems correct although it also has been acting intermittently. At the beginning of the season(2020) the unit appeared to be working- after reviewing this forum I took the following voltage readings

From MHU to Junction
Red 7.9 v
Blue 3.9 v
Green 4.9 v
Yellow 2.9 v

From Junction to unit
Red 7.9 v
Blue 3.2 v
Green 4.8 v
Yellow 2.6 v

The boat was at the dock at the wind was somewhat gusty and swirly. I was unable to measure at instrument because I couldn't pry off bezel ( I could on other instruments- any tips) - I will continue trying- any preliminary thoughts

Thanks
Find all posts by this user
Quote this message in a reply
05-20-20, 12:58 PM
Post: #2
RE: i60 Wind - No wind speed Readings
Hello nveater,

Those readings are good so they would indicate the masthead and cable are good. I would suspect the ST60 or the spade terminal connections on the back of the unit to be the culprit here.

Chris,


Attached File(s)
.pdf  Diagnostic Masthead Wind ST 60.pdf (Size: 31.74 KB / Downloads: 16)
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)