Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Upgrading autopilot 650 to ?
06-02-20, 01:50 AM
Post: #2
RE: [TG11] Upgrading autopilot 650 to ?
Hello Napier8121,

It's not actually the pilot display that affects the integration with MFDs, it's the black-box Course Computer. In a system of that age with an RP650 display I expect you have a Type 100 or Type 300 CC, which talks Seatalk1. You can connect ST1 pilots like those to a more modern MFD either on direct Seatalk1 (most MFDs up to the Widescreen generation, including C120 Classic and C120W) or to more recent and current MFDs via a Seatalk1 - SeatalkNG convertor.
If you did want still to update the pilot display, you can use a p70RS display with your existing CC. Connect the new display via an ST1-STNG 3-pin to 6-pin adaptor cable, e.g. A06073, rather than putting it on the STNG side of the convertor. This is because the convertor's software was designed to use ST1 displays with STNG pilots rather than the other way round.

You can replace the Tridata with an updated i50 Tridata and connect it to STNG via the convertor.

You can see the VHF range here. The closest in footprint size to your existing radio would be the Ray73, but otherwise you could perhaps use the neater Ray53 and put the dash space you save to better use.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Upgrading autopilot 650 to ? - Tom - Raymarine - Moderator - 06-02-20 01:50 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)