Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG11] New Axiom old auto pilot
06-01-20, 02:08 PM (This post was last modified: 06-11-20 12:00 AM by Tom - Raymarine - Moderator.)
Post: #1
[TG11] New Axiom old auto pilot
I recently upgraded my chart plotter to Axiom but still have my last generation Ray Marine auto pilot. I can’t seem to get the two to interface.
Find all posts by this user
Quote this message in a reply
06-11-20, 12:02 AM
Post: #2
RE: [TG11] New Axiom old auto pilot
Hello Ginodelg,

Axiom displays cannot calibrate or control previous-generation autopilots, but can send waypoint data to them for Track mode and can receive heading data from them. How are the two connected? Have you checked to see whether you are receiving heading data, and whether if you do a Goto on the Axiom then you can engage Track on the pilot display? If you can do these then they are interfaced correctly.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)