Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ACU-200 Drain Wire
12-13-16, 01:12 AM
Post: #1
ACU-200 Drain Wire
My boat's bonding system connects to the DC ground at a busbar that is located within 12" of where I am planning to mount the ACU-200. Would it be acceptable to connected the drain wire from the ACU-200 to the same terminal on the busbar where the bonding wire connects?
Find all posts by this user
Quote this message in a reply
12-14-16, 09:17 AM (This post was last modified: 12-21-16 03:09 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: ACU-200 Drain Wire
Welcome to the Raymarine Forum Don,

Should the heaving bonding cable be directly connected to the bus bar and the bus bar not also be used for grounding AC onboard the vessel, then a drain lead may be connected from the ACU to the bus bar.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)