Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Yamaha Digital to Analog to ES128
03-20-17, 06:04 PM
Post: #1
Yamaha Digital to Analog to ES128
Hello-
I have Digital Command Link Plus digital controls on my boat with the ES128. With my old set up I had to have the Digital to Analog adapter from Yamaha: 6Y9-8A2D0-30-00 to support my TR1 Gladiator.

http://yamahaoutboards.com/Marine_Riggin.../z#noFlash

Since that is not being used anymore I was curious if I could use this adapter to connect to my ES128 and receive RPM data to my ES128?

Any thoughts on this approach?
Thanks,
Brett
Find all posts by this user
Quote this message in a reply
03-21-17, 10:47 AM (This post was last modified: 03-21-17 10:47 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Yamaha Digital to Analog to ES128
Brett,

I would recommend contacting Yamaha concerning the compatibility of the subject adapter for use with your engines whether it would support supplying engine data (RPMs, etc.) to a NMEA 2000 backbone. If so, then it may be interfaced as a spur to a powered and properly terminated SeaTalkng backbone to which the MFD as also been interfaced as a spur. For such Yamaha engine systems, it is recommended that Raymarine's ECI100 Engine Gateway be used to interface the engine system the SeaTalkng backbone. Please click here to view a FAQ addressing this subject.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)