The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ITC-5 voltage
07-17-17, 01:37 PM
Post: #1
ITC-5 voltage
I have wind, speed and depth transducers connected to ITC-5 converter, connected to I70 instruments and ES plotter. Recently Wind direction indicator stopped reading wind direction change. Indicator on instrument only changes slightly from "stuck "position. I did test of wind transducer and read only 6 volts between red and ground. I supplied 8 volts from separate power supply and wind instrument preformed normally. The 6 volts was read off of the ITC-5 at wind power spade connector. All other instruments are working fine. I read 8 volts at the speed power connection and wondered if I could safely draw wind power from the speed power connection until I was in a position to replace or repair the ITC-5 converter. If indeed thats the problem.
Thank you for in advance for your help.
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
ITC-5 voltage - Randy - 07-17-17 01:37 PM
RE: ITC-5 voltage - Randy - 07-27-17, 07:41 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)