Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Axiom v3.2.86 reboots
09-19-17, 09:03 AM
Post: #1
Axiom v3.2.86 reboots
when powering down data master, slave reboots
Find all posts by this user
Quote this message in a reply
09-19-17, 09:53 AM
Post: #2
RE: Axiom v3.2.86 reboots
Welcome to the Raymarine Forum qbayle,

It is quite possible that the observed behavior may occur. The non-Data Master MFDs are very much dependent upon communications with the Data Master MFD. Should one not be shutting the equipment down by switching OFF the breaker / circuit switch supplying power to the MFDs, then it would be recommended that the non-Data Master MFDs be switched OFF prior to switching OFF the Data Master MFD. I favor using the breaker / circuit switch to control the power state of the MFDs.
Find all posts by this user
Quote this message in a reply
09-19-17, 10:05 AM (This post was last modified: 09-19-17 11:18 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: Axiom v3.2.86 reboots
So it's okay to just use a switch to power off the units vs using the shutdown button then a switch to shut off the power?
Find all posts by this user
Quote this message in a reply
09-19-17, 11:20 AM
Post: #4
RE: Axiom v3.2.86 reboots
Qbayle,

Is is indeed permissible to power the MFDs ON/OFF via the circuit supplying the MFDs with power. Please click here to view a FAQ addressing this subject.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)