Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] Two displays - sharing AIS and charts?
01-08-18, 05:15 PM (This post was last modified: 01-08-18 09:45 PM by Tom - Raymarine - Moderator.)
Post: #1
[TG] Two displays - sharing AIS and charts?
Hello:

I have two Raymarine MFD's on board my yacht, one is a C-80 and the other a C-70. They are both connected to the SeaTalk network.
Both units show all the transducer information (wind, compass, depth etc) fine.
Can I share one chart onto the two displays, or do I need two separate charts?

Thanks
IcarusBop
Find all posts by this user
Quote this message in a reply
01-08-18, 09:48 PM
Post: #2
RE: [TG] Two displays - sharing AIS and charts?
Good day IcarusBop,

C-series Classic were designed as single-station displays and have no capability to share graphical information such as charts, radar or sounder/fishfinder. The displays of that era that could do that were the E-series Classic (E80, E120). You will need separate charts in your C80 and C70.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Visit this user's website Find all posts by this user
Quote this message in a reply
01-09-18, 04:39 AM (This post was last modified: 01-09-18 02:55 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [TG] Two displays - sharing AIS and charts?
That's what I suspected - never mind, thanks very much for your response.
Find all posts by this user
Quote this message in a reply
01-10-18, 09:38 AM
Post: #4
RE: [TG] Two displays - sharing AIS and charts?
You're welcome.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)