[CA] ECI-100 install to the Raymarine Axiom

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] ECI-100 install to the Raymarine Axiom

02-26-18, 02:53 PM (This post was last modified: 02-26-18 02:56 PM by Chuck - Raymarine - Moderator.)

Post: #2

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA] ECI-100 install to the Raymarine Axiom

Welcome to the Raymarine Forum Ian,

Should you not be familiar with your engine's interfaces, then I would strongly recommend contacting the boat builder, Yanmar, or a Certified Raymarine Installer to assist with the installation. The boat builder or Yanmar may be able to identify whether a NMEA 2000 backbone was installed to support the engine system's instrumentation and/or controls, or where each engine's NMEA 2000 connector may be located.

« Next Oldest | Next Newest »

Messages In This Thread

[CA] ECI-100 install to the Raymarine Axiom - searat11 - 02-26-18, 01:58 PM

RE: [CA] ECI-100 install to the Raymarine Axiom - Chuck - Raymarine - Moderator - 02-26-18 02:53 PM

RE: [CA] ECI-100 install to the Raymarine Axiom - searat11 - 02-27-18, 11:37 AM

RE: [CA] ECI-100 install to the Raymarine Axiom - Chuck - Raymarine - Moderator - 02-27-18, 03:42 PM

User(s) browsing this thread: 1 Guest(s)