Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom in-hull transducer
03-27-18, 08:54 PM (This post was last modified: 03-28-18 03:32 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Axiom in-hull transducer
Hi Support,

I have two Axiom MFD units on my boat. An Axiom 7 DV & an Axiom 9 RV. I'm looking to install an Airmar or Raymarine in-hull P79 transducer. Since I already have my Axiom 9 "RV" installed to a RV transom mount transducer, I will be directly connecting to my Axiom 7 "DV". I have a raynet cable between the two screens.

Q: Which model P79 transducer should I buy for my Axiom 7 DV?
Q: Which adapter is needed for this conversion?


Thank you for your assistance!
Find all posts by this user
Quote this message in a reply
03-28-18, 03:39 PM
Post: #2
RE: [CA] Axiom in-hull transducer
Welcome to the Raymarine Forum Solo_Cam21,

Q1: Which model P79 transducer should I buy for my Axiom 7 DV?
A1: As you have not yet purchased a transducer, it is recommended that Raymarine's E66008 version of the P79 be purchased for this application.

Q2: Which adapter is needed for this conversion?
A2. It is recommended that the A80492 Y-Cable be used with the RV transducer and the above CP370 compatible transducer such as that listed in the response to Q1.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)