Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(DG) T120 replacement set up
04-19-18, 08:42 AM (This post was last modified: 04-20-18 04:55 AM by Derek - Raymarine - Moderator.)
Post: #1
(DG) T120 replacement set up
I have a replacement T120 wind transmitter for use with a Tacktick MN100 display.
Looking for instructions on how to sync the new masthead device. Any help or setup document is appreciated. Thank you
Find all posts by this user
Quote this message in a reply
04-20-18, 05:15 AM (This post was last modified: 04-20-18 05:31 AM by Derek - Raymarine - Moderator.)
Post: #2
RE: (DG) T120 replacement set up
Hi GLE

Thank you for your enquiry below.

The new Masthead Transmitter will need to be Auto Networked to the existing displays on the boat, for this to happen the masthead transmitter must be positioned within 300mm of the display.

Full instructions can be found on the Raymarine website select here and then search in the DOCUMENTS section for the Autonetworking guide.

regards


Attached File(s)
.pdf  UU071-rev06 autonetworking guide.pdf (Size: 505.56 KB / Downloads: 603)
Find all posts by this user
Quote this message in a reply
04-20-18, 08:10 AM (This post was last modified: 04-20-18 08:32 AM by Derek - Raymarine - Moderator.)
Post: #3
RE: (DG) T120 replacement set up
Thank you -
just to confirm transmitter distance...300 millimeters? like side by side?
Find all posts by this user
Quote this message in a reply
04-20-18, 08:33 AM
Post: #4
RE: (DG) T120 replacement set up
Hi GLE

Yes, 300mm - side by side.

thanks
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)