Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
i50 Depth: Shallow Cut Off
04-14-16, 05:57 AM
Post: #3
RE: i50 Depth: Shallow Cut Off
(04-13-16 09:45 AM)Steve - Raymarine - Moderator Wrote:  What type of transducer are you using in the system? When the system works then doesn't work, then works again. This points either to transducer placement or the angle the transducer is mounted. The transducer signal is not getting back to the transducer in the shallow water.

Reply: The transducer I am using is the one installed for the previous version of the i50 depth gauge. It works fine and consistently when in water over 7 +/- feet. Yesterday I snorkled down and looked at the transducer. It was covered with ablative bottom paint. I scraped off the paint but have not had a chance to test operation in shallow water. Does this sound like a likely fix to you? Thanks
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
i50 Depth: Shallow Cut Off - Tgause - 04-12-16, 08:48 PM
RE: i50 Depth: Shallow Cut Off - Tgause - 04-14-16 05:57 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)