Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG] No Pilot Error P70
08-24-18, 04:18 PM (This post was last modified: 09-06-18 05:54 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG] No Pilot Error P70
Long story short. A modified cable was plugged into the Seatalk network that should not of been. It was removed but now the autopilot control head reports no pilot. I have checked the "about this system" and the only item reporting is the p70. The ACU100 and EV1 do not show. I have checked all of the network connections and the Seatalk power leg. The EV100 shows green LED and the EV1 shows a flashing red LED. Any other advise on identifying the damaged component?
Find all posts by this user
Quote this message in a reply
09-06-18, 06:02 AM
Post: #2
RE: [DG] No Pilot Error P70
Hi KomatsuShawn

Thankyou for your enquiry,

The flashing red LED on the EV1 suggests there is an issue with the EV1 and so would start diagnostics at that point, try to reset it or upload new software into it on its own on a small isolated backbone.
Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)