Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] ST60 Total failure
02-28-19, 06:11 PM (This post was last modified: 03-01-19 11:44 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] ST60 Total failure
Hi my apologies if I have posted this twice, I cant find my original.

I have ST60 wind depth and speed. They started flashing and malfunctioning then started again briefly with a factory reset on depth speed etc.

They have now stopped altogether giving just blank screens, there is power to the displays but I cannot turn them on.

Any ideas?
Find all posts by this user
Quote this message in a reply
03-01-19, 11:47 AM
Post: #2
RE: [DG11] ST60 Total failure
Hi cdt

Thank you for your enquiry

first check power supplies and connections, there should be a good 12v measured between the red wire and the screen (shield) in the main SeaTalk wire, if there is a drop in voltage or loose connection then this will need to be rectified first.

try to connect the red to a separate +12v power supply and the screen (shield) to a -ve 0volt supply, isolate each instrument from SeaTalk and just try to power each one up on its own, this will identify any cable, connection problems or faults in a display which is causing the malfunction.

Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)