Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Yamaha to Raymarine MFD
04-02-19, 01:14 PM (This post was last modified: 04-02-19 01:55 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Yamaha to Raymarine MFD
I've read through the related posts and attempted to find an answer, but for the life of me I can't. I'm attempting to link my 2017 F200 to my E127. I have the command link cable from outboard, the E70242 cable to go from Yamaha to the ECI-100 and then to my NMEA 2000 backbone. The question I have is...can I go from Yamaha command link cable, to Raymarine E70242 cable, to ECI-100 or do I have to also install a full Yamaha Hub? Seems like an unnecessary step as I have no other command link gauges. Any ideas?
Find all posts by this user
Quote this message in a reply
04-02-19, 02:02 PM
Post: #2
RE: [CA11] Yamaha to Raymarine MFD
Welcome to the Raymarine Forum Hoehn000,

Q. can I go from Yamaha command link cable, to Raymarine E70242 cable, to ECI-100 or do I have to also install a full Yamaha Hub?
A. Negative. Like products having a SeaTalkng / NMEA 2000 communications interface, Yamaha engines, Command Link+ gauges, Command Link Plus controls, Command Link plus displays, and engine gateways, these items are each designed to be interfaced as individual spurs to a powered and properly terminated CAN bus. The engine gateway, in this case the ECI-100, will be interfaced as a spur to the engine CAN bus (Yamaha Hub ... supplied with proper termination and power) and as a spur to the marine electronics powered and properly terminated SeaTalkng / NMEA 2000 backbone.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)